Elmdene GEN2-08-B 12VDC Switch Mode Power Supply Unit 1A

Part Number: GEN2-08-B
Categories: Door Hardware (Access Control Systems), Power Supply Units

£51.73 (£62.08 inc VAT)

Elmdene GEN2-08-B 12VDC Switch Mode Power Supply Unit 1A

The GEN series of switch mode power supplies has been specifically designed to provide a comprehensive and flexible range for engineers designing intruder alarm systems to Grade 2 and Grade 3 under EN50131-6:2008 and PD6662:2010.

The new switch mode GEN range of power supplies has been specifically designed to provide a comprehensive range for engineers designing intruder alarm systems to Grade 2 and Grade 3 under PD6662:2010 EN50131-6:2008.

Both grades of product are available in two power variants with a range of enclosure sizes providing the required space for the standby battery.

Two LED’s assist with quick and easy installation by showing presence of mains, correct battery charging or a fault condition, whilst fault outputs are available to relay this information back to the intruder panel. Each PSU incorporates intelligent battery management comprising of full load battery testing, low battery voltage detection and deep discharge protection.

PSU protection is built-in as standard including mains transient filtering, electronic output overload protection and fuses on the load and battery outputs.

Key Features

13.8V dc output
Cost effective switch mode technology
Energy efficient:
More efficient in operation
Saves power so reducing power bills
Longer life in the field
Less prone to failure
Full current to load plus additional current to charge standby battery
Comprehensive battery management:
Deep discharge protection
Battery fault detection (Grade 3)
High efficiency 3 stage charging
Internal LED PSU status Mains transient protection • Electronic overload protection • High security front tamper (Grade 2)
High security front and rear tamper (Grade 3)
Fault outputs:
EPS fault (mains fail)
APS fault (battery fault)
PSU fault (general fault)
Screen printing available
3 year warranty
+ additional current for battery charging.
Grade 2 Intruder systems, will accommodate Communication Devices.
Mains, Battery and PSU volt free fault outputs.
Diagnostic LEDs.
Lid tamper.
Low quiescent battery standby current.
Fit up to 7Ah battery. 'B' Box: 330h x 355w x 80d - Clam lid.