Elmdene GEN3-08-C Switch Mode Power Supply Unit 1A
- Part Number: GEN3-08-C
- Categories: Door Hardware (Access Control Systems), Power Supply Units
Please note: This product is now obsolete. The recommended replacement is the GEN3-08-B.
Elmdene GEN3-08-C Switch Mode Power Supply Unit 1A
The GEN series of switch mode power supplies has been specifically designed to provide a comprehensive and flexible range for engineers designing intruder alarm systems to Grade 2 and Grade 3 under EN50131-6:2008 and PD6662:2010.
Key Features
- 13.8V dc output
- Cost effective switch mode technology
- Energy efficient:
- More efficient in operation
- Saves power so reducing power bills
- Longer life in the field
- Less prone to failure
- Full current to load plus additional current to charge standby battery
- Comprehensive battery management:
- Deep discharge protection
- Battery fault detection (Grade 3)
- High efficiency 3 stage charging
- Internal LED PSU status Mains transient protection
- Electronic overload protection
- High security front tamper (Grade 2)
- High security front and rear tamper (Grade 3)
- Fault outputs:
- EPS fault (mains fail)
- APS fault (battery fault)
- PSU fault (general fault)
- Screen printing available
- 3 year warranty
- + additional current for battery charging.
- Grade 3 Intruder systems.
- Mains, Battery and PSU volt free fault outputs.
- Diagnostic LEDs.
- Lid & rear tamper.
- Low quiescent battery standby current.
- Fit up to 7Ah battery. 'C' Box: 275h x 330w x 80d - Hinge lid
Please note: The image is for illustrative purposes only. Please contact us for further information.
Elmdene - GEN3-08-C - Manual (929.6KB)
Elmdene - GEN Range - Datasheet (943.06KB)
Elmdene - GEN3-08-C - Technical Datasheet (150.97KB)
Elmdene - Product Guide (5.96MB)
Have you got a question about this product?
Email us or Call Us on +44 (0)1254 207532














