Ciqurix CT-MHBB-106 Control Hub Rackmount

Ciqurix CT-MHBB-106 Control Hub Rackmount

The central point for any FCam CORE system, the Control Hub is a fully assembled and pre- configured rack unit which provides control and interface functions for the FCam CORE system.

The Control Hub supports up to 6 QLS devices (CORE cameras or modules) directly, and up to 128 with the use of Extension Hubs.

It is also available in a dust-proof wall-mount enclosure, see CT-MHBB-206.

Key Features

• Meets the requirements of BS5839-1 for L1-5 and P1-2 category systems (with remote fault monitoring)
• During a mains failure the Control Hub will continue to power itself and up to six attached QLS devices for 24 hours in standby plus 30 minutes in alarm. NB The NVR recorder and any other ancillary equipment is not battery-backed
• Designed specifically for use with fire-rated "FP" data cable, all cable termination is via punchdown block or screw terminal, all of which are clearly labelled and accessible from the front panel
• Cable entry to the cabinet is via 20mm glands, which are supplied ready-fitted so no drilling is required
• Four programmable alarm relays plus two fault relays provide universally compatible signalling to other systems, eg. fire alarm, fire suppression, remote communicator
• CORE I/O Modules can be connected if additional outputs are required. Each Module provides four programmable outputs
• Voltage: 220-240Vac 50Hz
• Current: 4A (inrush max 30A<30ms)
• Batteries: Yuasa NPL65-12l 65Ah 12V VRLA x 2 (included)
• Temperature: +5 to +40 °C < 90% Humidity
• Environment: No ingress protection – for use in clean dry areas only