Vimpex Signaline SL-UCB Universal Connection Box

Vimpex Signaline SL-UCB Universal Connection Box for Signaline Linear Heat Detection Cables and Controllers (Use for EOL, Junction Box or Interposing Line Unit)

The Signaline Universal Connection Box is suitable for use with all variants of Signaline FT-68, FT-88, FT-105 and HD. It can be used as an end of line enclosure, junction box or an interposing line unit. This all-in-one solution reduces on site time and cost. It uses heat rated terminals and glands can be used with any Signaline linear heat detector.

The IP66 rated enclosure provides a quick and efficient method to interconnect, terminate and join lengths of any Signaline heat sensing cable. It can also be used for connecting the incoming leader cable to the start of a length of heat sensing cable.

It is supplied with cable glands, 1x terminal block, 1x 470ohm resistor and 1x 680ohm resistor. Included resistors allow a Signaline FT cable to be connected directly to the zone terminals of most conventional fire control panels.

The Signaline UCB is suitable for use with these cables:

• Signaline FT-68
• Signaline FT-68-R
• Signaline FT-88
• Signaline FT-88-R
• Signaline FT-105
• Signaline FT-105-R
• Signaline HD
• Signaline HD-R
• Signaline HD-S

Key Features

• IP Rating: IP66
• Dimensions (excluding cable glands): 94 x 94 x 57 mm
• Material: Impact and flame resistant polycarbonate
• Colour: RAL 7035 Grey
• Chemical resistance: Resistant to most acids, alkalis and oils
• Operating Temp: -35°C to 120°C