Vimpex Signaline SL-HD-SKM-95 HD Controller for use with Apollo XP95 Intelligent Systems

Please note: This product is now obsolete, please contact us for further information.

Vimpex Signaline SL-HD-SKM-95 HD Controller for use with Apollo XP95 Intelligent Systems, complete with EOL, EN54-5 VdS Approved

Signaline HD analogue heat sensing cable must be used with a Signaline HD controller and End of Line Unit. These enable the Signaline HD heat sensing cable to be fully monitored for open and short circuit. The controllers are equipped with volt free fire and fault relays that are connected to the fire control panel via an Interposing Line Unit. Alternatively the Controller can be used as a standalone device using the relay contacts to activate subsidiary equipment.

Key Features

• Easy and economical to install
• Very simple to set up and operate
• Controller will monitor up to 300 m of sensor cable (dependent on ambient temperature)
• The sensor cable is resistant to corrosion and moisture and can be reset after use
• Loop powered addressable controller for use on Apollo XP95 protocol systems
• The Signaline-HD-SKM-95 is VdS approved EN 54 part 5 & 17