Tyco 557.202.003 PSM800 Power Supply Unit (Not for MX2)

Tyco 557.202.003 PSM800 Power Supply Unit (Not for MX2)

The PSM800 Power Supply and Battery Charger can provide power for a wide range of ancillary devices and may be used as a primary or auxiliary power supply. It contains an integral battery charger which continuously charges back-up batteries. The PSM800M is the Marine version.

The Power Supply Module is a regulated 24V dc @ 5A, isolated switching power supply that operates from 120-240V ac @ 50/60Hz.

Key Features:

• Power Factor correction and auto-adjusting input for universal 100/255V ac operation
• Boost converter providing regulated +24V dc outputs
• Short circuit protection and fault isolation
• Manual or automatic output shutdown
• Recharges batteries up to 110Ah (UL864)
• Battery installation protection and battery wiring monitoring
• Monitors battery charging voltage for low battery
• Missing or reverse battery
• Shorted battery wiring
• Remote reset facility
• Battery charger current limiting
• Battery charger and fault voltage temperature compensation
• Safe Extra low Voltage (SELV) outputs.
• Supplies controller power - regulated 5V dc @ 3A.
• Diagnostic LEDs for:
• AC OK
• Charger Fault
• Battery Fault
• Earth Fault