Signaline SL-HD-SKM03UK HD Controller

Please note: This product is now obsolete, please contact us for further information.

Signaline SL-HD-SKM03UK HD Controller

Special for use with conventional systems complete with EOL and DIP Switches for alarm temperature adjustment.

Signaline HD analogue heat sensing cable must be used with a Signaline HD controller and End of Line Unit. These enable the Signaline HD heat sensing cable to be fully monitored for open and short circuit. The controllers are equipped with volt free fire and fault relays that are connected to the fire control panel via an Interposing Line Unit. Alternatively, the Controller can be used as a standalone device using the relay contacts to activate subsidiary equipment.

• Manufacturer: Signaline
• Part Number: SL-HD-SKM03UK
• Easy and economical to install
• Very simple to set up and operate
• Controller will monitor up to 300 m of sensor cable (dependent on ambient temperature)
• The sensor cable is resistant to corrosion and moisture and can be reset after use
• For conventional systems and designed to raise an alarm when 1 m of Signaline HD cable is heated to 60 °C