Kentec INST-SFP-MM-01-K SFP Multi-Mode Fibre Optic Transceiver (550m)

Kentec INST-SFP-MM-01-K SFP Multi-Mode Fibre Optic Transceiver (550m)

INST-SFP-MM-01-K is a fibre optic transceiver for use with multimode fibre optic cable and operates at a nominal wavelength of 850nm.This dongle is locked and pre-configured for use with the Kentec DNX-R-2F/FC-K RS485/Fibre & Dual Fibre Dynamic Network Analyser.

INST-SFP-MM-01-K transceivers are hot-pluggable making it quick easy to replace and also swap between alternate fibre optic modes.

Maximum range will be dependent upon the fibre optic cable used 62.5/125?m range of 550m, 50/125?m can extend the range up to 1km. The transmitter section uses a Vertical Cavity Surface Emitted Laser and is class 1 laser compliant according to International Safety Standard IEC60825.

The receiver section uses an Integrated GaAs detector pre-amplifier (IDP) mounted in an optical header and a limiting post-amplifier IC. INST-SFP-MM-01-K is designed to be compliant with SFF-8472 MSA.

Built in digital diagnostic functions allow monitoring of the transceiver by the DNX-R-2F/FC-K analyser module and subsequently the IVIEW software tool. This allows performance monitoring along with early warning of a potential issue to enable preventative maintenance.

Key Features

• Plug-in transceiver for use with DNX-R-2F/FC-K analysers provides a multi-mode fibre communication link between transceivers on the network
• Max distance between analysers 550m
• Operating data rates up to 1.25Gbps
• Single 3.3V power supply and TTL Logic Interface
• Hot-pluggable SFP footprint duplex LC connector interface.
• Class 1 FDA and IEC60825-1 laser safety compliant.
• Commercial temperature range: -40~+85oC
• Compliant with SFF-8472 MSA
• Built-in digital diagnostic functions, including optical power monitoring