Protec 6000/CCO Clean Contact Interface Din Rail Mounted

Protec 6000/CCO Clean Contact Interface Din Rail Mounted

The Protec Clean Contact Interface is a loop powered output device providing a set of volt free changeover contacts. The contacts may be used to connect Protec addressable loops to any form of ancillary equipment.

The PROTEC 6000 / CCO module is powered by its own detection loop that incorporates a potential-free output switched contact and a short-circuit isolator that protects it from both input and output shorts.

The changeover contact supports up to 24 Vdc @ 1A. The equipment is prepared for mounting on a DIN rail.

Key Features

• Loop protocol: Protec Algo-tec™ 6000
• Loop isolator fitted: Yes, on board
• Loop voltage range: 16 to 28V peak loop
• Loop quiescent current: (24V peak loop) 0.6mA
• Loop alarm current (maximum): 19mA
• Clean contact output details: Single pole changeover rated for 1A maximum at 24V DC
• Indications: On-board red indicating LED
• Environmental operational limits: 0 to 50 degrees C (95% RH no condensation or icing)