Tyco 508.031.004 MZX-C 2 Zone Fire Panel (2 Wire)

Tyco 508.031.004 MZX-C 2 Zone Fire Panel (2 Wire)

The Minerva MZX-c range of conventional twin wire fire alarm control panels will satisfy a wide range of applications from 2 to 8 zones and have many features that are normally associated with more expensive addressable systems.

The Minerva MZX-c range of conventional fire detection control panels are designed to be both installer and user friendly. A high degree of flexibility and programmability allows the systems to be customised without the need for any configuration software.

The range consists of 2, 4 and 8 zone panels together with an 8 zone repeater which is compatible with the 4 and 8 zone variants. The matching repeater panel has an inbuilt 240Vac power supply.

Features

• 2, 4 and 8 zone versions available.
• Supports the complete range of EN54 approved series
• 600 detectors including photo multi-sensor and CO
  multi-sensor.
• Supports Tyco twin wire sounders on all eight detection zones.
• Drives up to 3 repeater panels (4 and 8 zone panels).
• Access to controls via key switch.
• Space for 2 x 3.4 A/H batteries providing up to 72 hour standby.
• Remote control inputs for class change, alert, evacuate, silence alarms and reset.
• Zone 1 configurable for latching or non latching.
• Selectable zonal or general alarm sounder operation.
• Alert sounder option.
• Configurable zone co-incidence for automatic detectors.
• Fully monitored fire signalling output.
• Single pole volt free change over fire relay output.
• Single pole volt free change over fail safe fault relay output.
• Short circuit fire option.
• Auxiliary 24VDC 250mA power supply output.
• Open collector output for buzzer active, disablement active and evacuate active.
• Earth fault monitoring.
• Zone/Output disablement for each zone, fire signal output and all sounders.
• Buzzer disable feature.
• One man zone test.
• One man sounder test.
• Automatic fire detector and manual alarm call point fire event discrimination.
• Alarm counter.
• Compatible with diode bases for detector removal.